Posted on

524WiFi™ Pulse Industrial Mesh: 400 Mb/s in a Ten-Hop IPQ5018 Test

524WiFi™ Pulse Industrial Mesh: 400 Mb/s in a Ten-Hop IPQ5018 Test

400 Mb/s at the end of a ten-hop chain is the sustained throughput reported by the supplier for its Qualcomm IPQ5018 mesh platform test.

How the test was arranged

The test diagram shows two wired endpoints at opposite ends of a chain of mesh access points. The links between access points were wireless. The published figure is end-to-end throughput from the supplier setup. Channel assignments, firmware and traffic parameters should be recorded in a site acceptance test.

Simplified ten-hop IPQ5018 test topology. Ethernet connects the two test endpoints to the mesh. Wireless links connect the access points. The supplier reported sustained throughput of 400 Mb/s at the receiver.
Simplified ten-hop IPQ5018 test topology. Ethernet connects the two test endpoints to the mesh. Wireless links connect the access points. The supplier reported sustained throughput of 400 Mb/s at the receiver.

Apply the reference to your site

Plan gateway capacity, relay placement and channel reuse around the client load. Measure sustained throughput and traffic interruption along the longest route, then repeat the test while the control and video flows are active and during recovery after a relay interruption.

Explore the 524WiFi™ Pulse indoor mesh node and 524WiFi™ Pulse outdoor mesh node. The industrial mesh design guide explains radio layout, roaming, QoS and commissioning.